Search for
Login | Username Password Forgot? | Email: | Create Account
View Feed
Education | Popularity: 0 | Entries: 85 | Modified: 678d 2h ago | | Add to My Feeds
11 Jul 15 Which security protocol or measure would provide the greatest protection for a wireless LAN? 1k  
11 Jul 15 Refer to the exhibit. All trunk links are operational and all VLANs are allowed on all trunk links. An ARP request is sent by computer 5. Which device or devices will receive this message? 1k  
11 Jul 15 Refer to the exhibit. Hosts A and B, connected to hub HB1, attempt to transmit a frame at the same time but a collision occurs. Which hosts will receive the collision jamming signal? 1k  
11 Jul 15 Refer to the exhibit. Router RA receives a packet with a source address of 192.168.1.65 and a destination address of 192.168.1.161. What will the router do with this packet? 1k  
11 Jul 15 Refer to the exhibit. Which two settings show the default value of VTP configuration on a Cisco 2960 switch? (Choose two.) 1k  
11 Jul 15 Which value determines if a switch becomes the central point of reference in the spanning tree topology? 1k  
11 Jul 15 Several Ethernet hosts on a LAN need the gateway services of a Cisco 2500 series router. Which of the following would be needed to physically connect a router to all of the hosts on the LAN? (Choose two.) 1k  
11 Jun 22 Which of the following describe interframe spacing? (Choose two.) 1k  
11 Jun 13 Refer to the exhibit. Host B attempts to establish a TCP/IP session with host C. During this attempt, a frame was captured at the FastEthernet interface fa0/1 of the San Francisco router. The packet inside the captured frame has the source IP address 10.1 1k  
11 Jun 13 What are three characteristics of CSMA/CD? (Choose three.) 1k  
11 Jun 13 Refer to the exhibit. The PC, the routing table of which is displayed, is configured correctly. To which network device or interface does the IP address 192.168.1.254 belong? 1k  
11 Jun 13 Refer to the exhibit. Host A wants to access the Internet. Which combination of a Layer 2 address and a Layer 3 address will enable this access from host A? 1k  
11 Jun 13 Refer to the exhibit. Communication between hosts X and Y is restricted to the local network. What is the reason for this? 1k  
11 Jun 13 What is the result of using the clock rate 56000 command at the serial interface of the router? 1k  
11 Jun 13 Which three addresses belong to the category of public IP addresses? (Choose three.) 1k  
11 Jun 13 Which three statements are true about transport layer protocols? (Choose three.) 1k  
11 Jun 13 Refer to the exhibit. Which logical topology describes the exhibited network? 1k  
11 Jun 13 Which statement is true about the running configuration file in a Cisco IOS device? 1k  
11 Jun 12 What feature allows network devices to be scalable? 1k  
11 Jun 12 Which command generated this output? 1k  
11 Jun 12 Which network utility helps determine the location of network problems and identifies routers that packets travel across? 1k  
11 Jun 12 What interconnects the Internet backbone? 1k  
11 Jun 12 What units are used to measure Internet bandwidth? 1k  
11 Jun 12 The IT manager of a medium-sized business wishes to house the company-owned web servers in a facility that offers round-the-clock controlled access, redundant power, and high-bandwidth Internet access. Which ISP service will fulfill this need? 1k  
11 Jun 12 What is the purpose of an RFC? 1k  
11 Jun 12 When did the Internet become available for use by businesses and consumers? 1k  
11 Jun 12 What was the original purpose of the Internet? 1k  
11 Jun 12 What three support service teams are commonly found within an ISP? (Choose three.) 1k  
11 Jun 10 Refer to the exhibit. The nslookup command that is shown was issued on a Windows PC host. What does the 10.32.5.74 address represent? 1k  
11 Jun 10 Which three addresses are private IP addresses? (Choose three.) 1k  
11 Jun 10 What are two major characteristics of a worm? (Choose two.) 1k  
11 Jun 10 While configuring a Frame Relay connection, when should a static Frame Relay map be used? 1k  
11 Jun 10 What is the result when the command permit tcp 192.168.4.0 0.0.3.255 any eq 23 is entered in a named access control list and applied on the inbound interface of a router? 1k  
11 Jun 10 Where does a service provider assume responsibility from a customer for a WAN connection? 1k  
11 Jun 10 Refer to the exhibit. The network administrator creates a standard access control list on Router1 to prohibit traffic from the 172.16.1.0/24 network from reaching the 172.16.2.0/24 network while still permitting Internet access for all networks. On which 1k  
11 Jun 10 A network administrator has changed the VLAN configurations on his network switches over the past weekend. How can the administrator determine if the additions and changes improved performance and availability on the company intranet? 1k  
11 Jun 10 Refer to the topology and router configutation shown in the graphic. A host on the LAN is accessing an FTP server across the Internet. Which of the following addresses could appear as a source address for the packets forwarded by the router to the destiti 1k  
11 Jun 10 what are two reasons that a network administrator wold use access lists? (Choose two.) 1k  
10 Dec 3 CCNA E1 Module 1 1k  
10 Dec 3 CCNA Discovery 1 Module 1 Exam Answers Version 4.0 1k  
10 Jun 17 Which three VTP parameters must be identical on all switches to participate in the same VTP domain? (Choose three.) 1k  
10 Jun 17 Refer to the exhibit. All switches in the network participate in the same VTP domain. What happens when the new switch SW2 with a default configuration and revision number of 0 is inserted in the existing VTP domain Lab Network? 1k  
10 Jun 17 Refer to the exhibit. Switch S1 is in VTP server mode. Switches S2 and S3 are in client mode. An administrator accidentally disconnects the cable from F0/1 on S2. What will the effect be? 1k  
10 Jun 17 Which two statements are true about the implementation of VTP? (Choose two.) 1k  
10 Jun 17 CCNA 2 – Module 11 8k  
10 Jun 13 Refer to the exhibit. Which statement correctly describes how Router1 processes an FTP request that enters interface s0/0/0 and is destined for an FTP server at IP address 192.168.1.5? 1k  
10 Jun 13 Refer to the exhibit. Which statement is true about the CSU/DSU device? 1k  
10 Jun 13 Refer to the exhibit. From the output of the show interfaces and ping commands, at which layer of the OSI model is a fault indicated? 1k  
10 Jun 13 Refer to the exhibit. A network administrator is trying to backup the IOS software on R1 to the TFTP server. He receives the error message that is shown in the exhibit, and cannot ping the TFTP server from R1. What is an action that can help to isolate th 1k  
10 Jun 13 Refer to the exhibit. Router1 is not able to communicate with its peer that is connected to this interface. Based on the output as shown, what is the most likely cause? 1k  
10 Jun 13 CCNA 3 – Chapter 4 10k  
10 Jun 13 A technician is talking to a colleague at a rival company and comparing DSL transfer rates between the two companies. Both companies are in the same city, use the same service provider, and have the same rate/service plan. What is the explanation for why 1k  
10 Jun 13 Refer to the exhibit. What is placed in the address field in the header of a frame that will travel from the DC router to the Orlando router? 1k  
10 Jun 13 When NAT is in use, what is used to determine the addresses that can be translated on a Cisco router? 1k  
10 Jun 13 A network administrator is tasked with maintaining two remote locations in the same city. Both locations use the same service provider and have the same service plan for DSL service. When comparing download rates, it is noticed that the location on the Ea 1k  
10 Jun 13 What are the symptoms when the s0/0/0 interface on a router is attached to an operational CSU/DSU that is generating a clock signal, but the far end router on the point-to-point link has not been activated? 1k  
10 Jun 13 A technician has been asked to run Cisco SDM one-step lockdown on the router of a customer. What will be the result of this process? 1k  
10 Jun 13 Refer to the exhibit. Which statement is true about the Frame Relay connection? 1k  
10 Jun 13 Which two statements are true about creating and applying access lists? (Choose two.) 1k  
10 Jun 13 A system administrator must provide Internet connectivity for ten hosts in a small remote office. The ISP has assigned two public IP addresses to this remote office. How can the system administrator configure the router to provide Internet access to all t 1k  
10 Jun 13 What are two effective measures for securing routers? (Choose two.) 1k  
10 Jun 13 Refer to the exhibit. A network administrator has issued the commands that are shown on Router1 and Router2. A later review of the routing tables reveals that neither router is learning the LAN network of the neighbor router. What is most likely the probl 1k  
10 Jun 13 Because of a remote-procedure call failure, a user is unable to access an NFS server. At what layer of the TCP/IP model does this problem occur? 1k  
10 Jun 13 What will be the result of adding the command ip dhcp excluded-address 192.168.24.1 192.168.24.5 to the configuration of a local router that has been configured as a DHCP server? 1k  
10 Jun 13 Refer to the exhibit. A network administrator is trying to configure a router to use SDM. After this configuration shown in the exhibit is applied, the SDM interface of the router is still not accessible. What is the cause of the problem? 1k  
10 Jun 13 Refer to the exhibit. A technician issues the show interface s0/0/0 command on R1 while troubleshooting a network problem. What two conclusions can be determined by from the output shown? (Choose two.) 1k  
10 Jun 13 Refer to the exhibit. Which DHCP requests will R1 answer? 1k  
10 Jun 13 Refer to the exhibit. Why are the routers unable to establish a PPP session? 1k  
10 Jun 13 A network administrator is instructing a technician on best practices for applying ACLs. Which suggestion should the administrator provide? 1k  
10 Jun 13 Refer to the exhibit. Switch1 is not participating in the VTP management process with the other switches shown in the exhibit. What are two possible reasons for this? (Choose two.) 1k  
10 Jun 13 Refer to the exhibit. Switches SW1 and SW2 are interconnected via a trunk link but failed to exchange VLAN information. The network administrator issued the show vtp status command to troubleshoot the problem. On the basis of the output provided, what cou 1k  
10 Jun 13 Refer to the exhibit. Which two facts can be confirmed by this output? (Choose two.) 1k  
10 Jun 13 Which two statements describe VTP transparent mode operation? (Choose two.) 1k  
10 Jun 13 Refer to the exhibit. Switch2 was previously used in a lab environment and has been added to the production network in server mode. The lab and production networks use the same VTP domain name, so the network administrator made no configuration changes to 1k  
10 Jun 13 What causes a VTP configured switch to issue a summary advertisement? 1k  
09 Aug 7 CCNA Exploration 2 – Module 6 1k  
09 Aug 7 CCNA 2 Module 7 1k  
09 Aug 7 CCNA Discovery 2 – Module 8 Exam 1k  
09 Aug 7 CCNA Exploration 2 – Module 9 Exam Answers Version 4.0 1k  
09 Aug 7 CCNA 3 FINAL- CCNA DISCOVERY 3 1k  
09 Aug 7 Refer to the exhibit. Which two conclusions can be drawn from the output shown? (Choose two.) 1k  
09 Aug 7 A system administrator must provide Internet connectivity for ten hosts in a small remote office. The ISP has assigned two public IP addresses to this remote office. How can the system administrator configure the router to provide Internet access to all t 1k  
09 Aug 7 Refer to the exhibit. Company ABC expanded its business and recently opened a new branch office in another country. IPv6 addresses have been used for the company network. The data servers Server1 and Server2 run applications which require end-to-end funct 1k  
09 Aug 7 Refer to the exhibit. You are a network administrator who has been tasked with completing the Frame Relay topology that interconnects two remote sites. How should the point-to-point subinterfaces be configured on HQ to complete the topology? 1k  
09 Aug 7 An established company has recently transitioned from outsourced LAN support to a completely in-house staff. The outsourcing company is no longer in business, so no records are available. There are many user complaints about application speed and availabi 1k  

^ Back To Top